Product Introduction
The GE IC695ETM001 Ethernet interface module is a key component of the PACSystems RX3i family, designed to provide robust Ethernet connectivity for industrial automation systems. This single-slot module features two RJ45 connectors supporting Ethernet/IP protocol, a 9-pin Sub-D station manager connector, and a reset pushbutton. With 10/100 Mbps transmission rates and auto-negotiation, the IC695ETM001 ensures reliable data exchange between controllers and field devices.
Key Features
- Two 10/100 Mbps Ethernet ports with autosensing and full/half duplex support
- RS-232 serial port with data rates from 1200 bps to 115200 bps
- Hot-swappable design for minimal downtime, firmware revision 2.51 required
- 200 MHz Ethernet processor with non-volatile memory for daisy-chaining
- Supports SRTP, Modbus TCP, and EGD protocols over TCP/IP
- Embedded switch with auto-negotiation, speed, and crossover detection
Real-World Applications
The GE IC695ETM001 excels in applications requiring reliable Ethernet communication between PACSystems RX3i controllers and other platforms such as Series 90 and VersaMax controllers. For example, in a manufacturing plant, it can integrate multiple PLCs for coordinated production line control. Its hot-swap capability reduces downtime during maintenance, while the RS-232 port allows local diagnostics. The module also supports time synchronization via SNTP, making it ideal for distributed control systems where precise timestamping is critical.
Installation & Setup
Install the GE IC695ETM001 into any empty RX3i backplane slot. Compatible backplanes include IC695CHS007, CHS012, or CHS016. The module supports insertion under power (hot-swap) but ensure firmware revision 2.51 is installed for this feature. Connect Ethernet cables to the RJ45 ports for network integration, and use the 9-pin D-sub connector for serial station manager access. The embedded switch automatically negotiates speed and duplex mode, simplifying configuration.
Compatibility & Integration
The GE IC695ETM001 is fully compatible with PACSystems RX3i controllers, except the CPE400. It communicates using SRTP, Modbus TCP, and Ethernet Global Data (EGD) protocols, enabling seamless integration with existing automation networks. The module also supports TCP/IP services over a four-layer stack, allowing it to act as both a Modbus TCP server and client. For remote monitoring, the station manager provides supervisory access via serial or Ethernet.
Selection Guide
When selecting the GE IC695ETM001, verify that your system uses a compatible RX3i backplane and that firmware revision 2.51 is installed for hot-swap functionality. This module is ideal for upgrading older Ethernet interfaces or expanding network capacity. For reliable sourcing and support, choose UBEST Automation. Contact us via ubest101.myshopify.com for further assistance.