Product Introduction
When machinery vibration threatens uptime, the Bently Nevada 9200-06-02-10-00 Two-Wire Velocity Seismoprobe Transducer delivers accurate, reliable monitoring. This industrial automation module is designed for critical rotating equipment, providing a direct velocity output for early fault detection. The 9200-06-02-10-00 belongs to the Model 9200 series, known for robust construction and wide temperature tolerance.
Technical Specifications
The Bently Nevada 9200-06-02-10-00 offers key performance parameters derived from factory data:
-
Sensitivity: 20 mV/mm/s (500 mV/in/s), ±5% when properly terminated and oriented at calibration angle
-
Calibration Load: 10 kΩ across terminals A and B
-
Sensitivity Temperature Coefficient: 0.2%/°C
-
Dynamic Operating Range: 2.54 mm (0.100 in) peak-to-peak maximum displacement
-
Velocity Range: 25 mm/s (1 in/s) at +22°C, 100 Hz, 10 kΩ load
-
Coil Resistance: 1.25 kΩ ±5%
-
Locked Coil Inductance: 125 mH, typical
-
Operating/Storage Temperature: -29°C to +121°C (-20°F to +250°F)
-
Environment: Dust and moisture resistant
-
Relative Humidity: To 95% noncondensing; 100% non-submerged with integral cable
-
Case Material: Anodized aluminum A204
-
Gasket Material: Neoprene
-
Height: 102 mm (4 in) typical depending on connector option
-
Diameter: 41 mm (1.6 in) typical
-
Weight: 300 grams (10.5 ounces) typical
Industry Applications
The Bently Nevada 9200-06-02-10-00 excels in harsh environments where temperature swings and dust threaten sensor accuracy. Common applications include:
- Steam turbine bearing vibration monitoring – its wide temperature range (-29°C to +121°C) suits turbine casing environments.
- Compressor and pump protection – the 2.54 mm dynamic range captures high-amplitude events before damage occurs.
- Fan and blower health monitoring – dust/moisture resistance ensures reliable operation in dirty air streams.
Installation & Setup Guidance
Mount the Bently Nevada 9200-06-02-10-00 using the circular M10×1 stud base (Option 10). The side-mount connector (Option 02) accepts no cable – terminate wiring with a suitable mating connector. Orient the transducer at the angle of calibration (0 ±100 degrees, minimum operating frequency 10 Hz) to maintain ±5% sensitivity tolerance. Connect a 10 kΩ load across terminals A and B for proper output. Ensure the mounting surface is clean and flat for accurate coupling.
Maintenance & Reliability
The Bently Nevada 9200-06-02-10-00 requires minimal upkeep. Its anodized aluminum case resists corrosion, and the neoprene gasket seals against moisture. Key maintenance points:
- Inspect connector for corrosion or loose contacts annually.
- Verify cable integrity if used with integral cable (order separately).
- Recalibrate sensitivity every two years or after extreme thermal cycling.
- Store below +121°C and avoid submersion unless ordered with integral cable.
Selection Guide & Purchasing Advice
When ordering the Bently Nevada 9200-06-02-10-00, verify your system requirements: load impedance (10 kΩ), mounting orientation, and temperature range. This transducer suits new installations or direct replacement of older two-wire velocity sensors. For reliable supply, contact ubest101 – PLC Source PRO offers new, factory-sealed units with 12-month warranty. Ensure your data acquisition card accepts 20 mV/mm/s velocity input at 10 kΩ termination.