Product Introduction
When unplanned downtime strikes rotating machinery, the Bently Nevada 9200-06-02-01-00 Two-Wire Velocity Seismoprobe Transducer provides early warning. This industrial automation module converts casing vibration into a proportional electrical signal, enabling predictive maintenance. Designed for harsh environments, the 9200-06-02-01-00 offers reliable performance in temperature extremes from -29°C to +121°C.
Technical Specifications Breakdown
Key parameters of the Bently Nevada 9200-06-02-01-00 include:
-
Sensitivity: 20 mV/mm/s (500 mV/in/s), ±5% when properly terminated and oriented at calibration angle.
-
Calibration Load: 10 kΩ between Terminal A and B.
-
Sensitivity Temperature Coefficient: 0.2%/°C.
-
Dynamic Operating Range: 2.54 mm (0.100 in) peak-to-peak maximum displacement.
-
Velocity Range: 25 mm/s (1 in/s) at +22°C, 100 Hz casing vibration with 10 kΩ load.
-
Coil Resistance: 1.25 kΩ ±5%.
-
Locked Coil Inductance: 125 mH typical.
-
Operating Temperature: -29°C to +121°C.
-
Relative Humidity: Up to 95% noncondensing; 100% non-submerged with integral cable.
-
Dimensions: Height 102 mm typical, diameter 41 mm typical.
-
Weight: 300 grams typical.
These specs ensure consistent vibration data for critical assets like turbines, compressors, and pumps.
Installation & Setup Guidance
Install the Bently Nevada 9200-06-02-01-00 at a 0° mounting angle (±100) with a minimum operating frequency of 10 Hz (600 cpm). Use the side-mount connector (option 02) with no cable. Secure the transducer using the circular mounting base with a 1/4-20 UNC stud (option 01). Ensure proper termination to achieve rated sensitivity. No special approvals are required (option 00).
Troubleshooting & Common Issues
Common problems with velocity transducers include incorrect wiring, loose mounting, or exceeding the dynamic range. Always verify the 10 kΩ calibration load across pins A and B. If readings drift, check the ambient temperature; the sensitivity temperature coefficient is 0.2%/°C. For the 9200-06-02-01-00, ensure the transducer is oriented at the calibration angle to maintain ±5% accuracy. Avoid submersion; the unit is dust and moisture resistant but not waterproof without integral cable.
Maintenance & Reliability
Routine inspection of the Bently Nevada 9200-06-02-01-00 is minimal. Check the neoprene gasket (for 9200 model) for deterioration. The anodized aluminum A204 case resists corrosion. Keep the mounting base clean and tight. The transducer's sealed design handles up to 95% humidity. With proper care, this module provides long-term reliability, reducing costly emergency repairs.
Selection Guide & Purchasing Advice
Before purchasing the Bently Nevada 9200-06-02-01-00, confirm your transducer mounting angle and minimum operating frequency requirement. Verify that your system accepts a two-wire velocity signal. For replacement applications, match the original mounting base option. PLC Source PRO offers this module new in factory packing with a 12-month warranty. Contact us at ubest101 for volume pricing or custom configurations.