Product Introduction
The Bently Nevada 83387-065 is a 65-inch hardline cable engineered for high-reliability connectivity between accelerometers and interface modules in critical industrial automation systems. This cable is part of Bently Nevada's proven line of rugged signal transmission solutions, designed to withstand extreme temperatures and harsh environments. The 83387-065 features a twisted shielded pair with mineral insulation and a stainless steel overbraid, providing superior protection against electromagnetic interference and mechanical damage.
Technical Specifications
Based on the product data sheet, the Bently Nevada 83387-065 hardline cable includes the following key characteristics:
| Parameter |
Value |
| Length |
65 inches |
| Accelerometer Mating Connector |
Mates to MS 3100R-10SL-4P receptacle; Viton insert |
| Disconnect Interface Mating Connector |
Mates to MS 3106-10SL-4S |
| Cable Construction |
Twisted shielded pair with mineral insulation; stainless steel overbraid |
| Operating Temperature (Cable) |
-65°F to +1200°F (-54°C to +649°C) |
| Operating Temperature (Accelerometer Connector) |
-65°F to +800°F (-54°C to +427°C) |
| Operating Temperature (Disconnect Connector) |
-65°F to +800°F (-54°C to +427°C) |
Industry Applications
The Bently Nevada 83387-065 is ideal for applications where standard cables fail due to extreme heat, vibration, or chemical exposure. Typical use cases include:
-
Gas turbine monitoring: The 83387-065 withstands the intense heat near turbine casings, ensuring continuous accelerometer signal integrity.
-
Steam turbine and boiler systems: High-temperature environments require the mineral-insulated design of this cable to prevent signal degradation.
-
Compressor and pump health monitoring: The rugged overbraid resists abrasion and mechanical stress in rotating machinery applications.
Installation & Setup
When installing the Bently Nevada 83387-065, ensure the accelerometer mating connector is properly aligned with the MS 3100R-10SL-4P receptacle and the Viton insert provides a secure, high-temperature seal. The disconnect interface connector should be mated to the MS 3106-10SL-4S on the interface module. Avoid sharp bends in the cable to maintain the integrity of the mineral insulation. For optimal performance, secure the cable along its length using appropriate clamps designed for high-temperature environments.
Maintenance & Reliability
The Bently Nevada 83387-065 is built for extended service life in extreme conditions. The stainless steel overbraid and mineral insulation offer superior resistance to heat, moisture, and mechanical wear. No routine maintenance is required under normal operating conditions, but periodic visual inspection for physical damage to the overbraid or connectors is recommended. If the cable is exposed to temperatures exceeding the rated limits, replace it immediately to prevent signal loss or equipment damage.
Buying Guide
Before purchasing the Bently Nevada 83387-065, verify the length requirement (65 inches) and confirm compatibility with your accelerometer and interface module connectors. This cable is specifically designed for use with Bently Nevada accelerometer interface modules that accept the MS 3106-10SL-4S connector. For other systems, verify connector type and electrical characteristics. PLC Source PRO (ubest101.myshopify.com) offers genuine Bently Nevada 83387-065 cables in new original factory packaging with a 12-month warranty.